(4) LVL has strong seismic performance and shock absorption performance, and can resist periodic fatigue damage. (3) The processing of LVL is the same as wood, which can be sawed, sliced, gouged, tenoned, nailed, etc. The utilization rate of raw materials is as high as 100% They can be cut and selected at will according to their own material conditions. The LVL products produced by our company can be up to 12 meters in length and 300 mm in thickness. (2) The size can be adjusted at will, and is not affected by the shape and defects of the log. It is the most ideal structural material to replace solid wood (1) LVL material can disperse and stagger defects such as knots and cracks of logs, thereby greatly reducing the impact on strength, making it stable in quality, uniform in strength, and small in material variability. Do not use scaffold planks as a base to stack materials, or as ramps or temporary roadways.Comparing LVL timber with solid wood sawn timber, it can be seen that LVL has many advantages that ordinary solid wood sawn timber does not have:.For bulk orders and pricing please contact us. Widely used in the scaffolding industry, hardwood timber sole boards are used to base out the scaffold where there is uneven ground or soft surfaces. Do not paint as the paint can conceal defects. Synergy’s formwork timber hardwood sole boards come in 225MM X 38MM X 500MM. Stack planks on a firm level surface to prevent warping.How should decking be stored? Back to top Check with officials in your local jurisdiction as recommendations may vary.Support planks at intervals not exceeding 3m (10 ft) for light work and 2.1 m (7 ft.) for heavy work (bricklaying, masonry).Overlap or extend planking 150 mm (6 in.) to 300 mm (12 in.) and cleat at each end to prevent planking from slipping and blowing off.Use a minimum of 48 mm thick Number 1 Grade spruce-pine-fir (SPF) planking or better. ![]() Try to plank the entire working level of a scaffold for maximum support and stability.Make sure that all working platforms are about 500 mm (20 in.) minimum in width.What are minimum recommendations for the deck? Back to top Do not jump on the planks to test their strength.Weather, rot, and general use can deteriorate the planks. Buchanan: This is in response to your fax submitted October 21, 2005, to the Occupational Safety and Health Administration (OSHA). Inspect planks on a regular basis while on the scaffold. Re: Whether plywood may be used as scaffold decking material over wood scaffold planks.Platform decks should be slip-resistant and should not accumulate water. Clean ice, snow, oil and grease off planks.Damage can occur if the platforms are dropped or thrown. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |